Simviation Forum - 3-view background images

	Search the archive:

Simviation Main Site | Site Search | Upload Images

Simviation Forum › Design Forums › Aircraft & 3D Design › 3-view background images

(Moderators: Mitch., Fly2e, ozzy72, beaky, Clipper, JBaymore, Bob70, BigTruck)

‹ Previous Topic | Next Topic ›

Pages: 1

3-view background images (Read 142 times)

Nov 10^th, 2003 at 9:18am

Smoke2much Offline
Colonel
The Unrepentant Heretic
Sittingbourne, Kent,

Posts: 3879

I found a 3-view image of the aircraft that I'm trying to build in G-max 12.

I have cropped the 3 views in photoshop and ensured that they are all central and that the dimensions match:

The front view is 396*92 Pixels
Side view 292*92 Pixels
Top View 396*292 Pixels

When I load them into GMax the top and front views match but the side view is about twice as large as it should be and cannot be persuaded to fit in the box of the correct dimensions.

If anyone can tell me what I've done wrong I'd be grateful.

Will

Who switched the lights off? I can't see a thing....... Hold on, my eyes were closed. Oops, my bad...............&&

IP Logged

Reply #1 - Nov 10^th, 2003 at 9:43am

Felix/FFDS Offline
Admin
FINALLY an official Granddad!
Orlando, FL

Gender:
Posts: 1000000627

Assuming you're just setting the viewport image, I suggest you map the images to planes of the same dimensions....

i.e. map the front view to a plane in the "rear" view (K) of 396*92 units, the side to a plane of 292*92 units, etc.

Note that you can group these reference planes and "freeze" them once you've scaled everything properly (remember to uncheck the "show frozen in gray" box in the properties.

Basically, by having the images in their own obnject/planes, you can scale the planes correctly, and not have the viewports go nutty...

Felix/FFDS

IP Logged

Reply #2 - Nov 10^th, 2003 at 9:04pm

Smoke2much Offline
Colonel
The Unrepentant Heretic
Sittingbourne, Kent,

Posts: 3879

Thanks Felix, It's not making sense yet but I have printed your tutorial and I'm working on it.... Must not kill or maim innocent passers by..... Arrgh

Will

Who switched the lights off? I can't see a thing....... Hold on, my eyes were closed. Oops, my bad...............&&

IP Logged

Reply #3 - Nov 10^th, 2003 at 9:19pm

Felix/FFDS Offline
Admin
FINALLY an official Granddad!
Orlando, FL

Gender:
Posts: 1000000627

If you're talking about the FW190 tutorial from the 3DWorld Magazine at my aerodynamika.com site, it's better than the P-38, granted.

For mapping the planes, use the Backgrounds Tutorial from X_eidos.

Felix/FFDS

IP Logged

Reply #4 - Nov 10^th, 2003 at 9:35pm

Smoke2much Offline
Colonel
The Unrepentant Heretic
Sittingbourne, Kent,

Posts: 3879

Thanks, I will.

The Bitmaps are lined up now in two dimensions but not in the third. I had no worries with a fuselage cylinder but when I tried to put the wing on it was in completely the wrong place LOL.

Will

Who switched the lights off? I can't see a thing....... Hold on, my eyes were closed. Oops, my bad...............&&

IP Logged

Pages: 1

‹ Previous Topic | Next Topic ›

« Home

‹ Board

Top of this page