Simviation Forum - Need to add grass!

	Search the archive:

Simviation Main Site | Site Search | Upload Images

Simviation Forum › Design Forums › Scenery & Panel Design › Need to add grass!

(Moderators: Mitch., Fly2e, ozzy72, beaky, Clipper, JBaymore, Bob70, BigTruck)

‹ Previous Topic | Next Topic ›

Pages: 1

Need to add grass! (Read 414 times)

Jul 25^th, 2011 at 7:33pm

Capt._Viper Offline
Colonel
Turning and Burning the
40's Way.
NC, United States

Gender:
Posts: 162

I am wanting to add the new 36L to Charlotte-Douglas(KCLT) that is west of the older 36L, the problem is that tthere is no grass textures in the area. What should I do to remedie this? Can include a picure if needed

IP Logged

Reply #1 - Jul 25^th, 2011 at 9:38pm

dave3cu Offline
Colonel
Procrastinate now, don't
put it off.
3CU, Northern Wisconsin, USA

Gender:
Posts: 3077

FS2004 or FSX?

What scenery design tools do you have or are using ? Sbuilder, ADE9X, Afcad2, others.

At that time [1909] the chief engineer was almost always the chief test pilot as well. That had the fortunate result of eliminating poor engineering early in aviation. Igor Sikorsky

I intend to live forever....so far, so good. Steven Wright

You know....you can just rip up a to-do list.

IP Logged

Reply #2 - Jul 26^th, 2011 at 9:20am

Capt._Viper Offline
Colonel
Turning and Burning the
40's Way.
NC, United States

Gender:
Posts: 162

I have ADE9, Sbuilder and AFCAD 2 installed.

« Last Edit: Jul 26^th, 2011 at 1:21pm by Capt._Viper »

IP Logged

Reply #3 - Jul 27^th, 2011 at 12:01am

dave3cu Offline
Colonel
Procrastinate now, don't
put it off.
3CU, Northern Wisconsin, USA

Gender:
Posts: 3077

Saw your reply earlier but didn't have the time to reply then. I see you added SBuilder to the list. That is what you use to create the new grass area. From your list I assume you're designing for FS2004.

Sbuilder-make sure you have the latest version. Click Help>About and should be Version 2.05 Revision 06. If not, you can download the latest version here-http://www.fsdeveloper.com/forum/downloads.php?do=file&id=68KCLT.zip

You'll need to create 2 polygons to define the new grass area. You'll create them one on top of the other but leave at least part of an edge on the lower one exposed so you can easily get at it to edit if necessary.

1) an LWM-Flatten with an 'all points' altitude of 227.99M

2) a VTP2-filled with the a landclass (bullet next to Classes-click in Classes input line to open Landclass selection window). 095-Grasslands or 096-Grasslands fit nicely.

If you need any further help, just holler.

Dave

« Last Edit: Jul 27^th, 2011 at 6:25pm by dave3cu »

IP Logged

Pages: 1

‹ Previous Topic | Next Topic ›

« Home

‹ Board

Top of this page