Simviation Forum - More Poly Probs

	Search the archive:

Simviation Main Site | Site Search | Upload Images

Simviation Forum › Design Forums › Aircraft & 3D Design › More Poly Probs

(Moderators: Mitch., Fly2e, ozzy72, beaky, Clipper, JBaymore, Bob70, BigTruck)

‹ Previous Topic | Next Topic ›

Pages: 1

More Poly Probs (Read 718 times)

Feb 23^rd, 2003 at 10:27am

striker Offline
Colonel
Don't read this. Read
my post.
Wilmington, NC

Posts: 110

Me & polygons just don't get along.
Again I've run into trouble. When cutting windows I noticed a poly had formed accross one of the cross sections - just behind the main canopy. This blocks the view inside the cabin.

I have tried selecting all, flipping & my patience is running thin. Any ideas would be appreciated.
I hope these illustrations show what I mean.

IP Logged

Reply #1 - Feb 23^rd, 2003 at 11:13am

guimero Offline
Colonel
plane finished!!!

Posts: 52

If I were you I would select your part and then click on polygon icon to be in poligon mode. Prees the "n" key until the polygon that you don't want is selected. (you will see a white line coming out of it) And then press the delete key. It should work.

IP Logged

Reply #2 - Feb 23^rd, 2003 at 11:34am

striker Offline
Colonel
Don't read this. Read
my post.
Wilmington, NC

Posts: 110

Thanks Guimero! You were right! Funny enough the polygon was selectable along with the ones near the front nose, not beside ajacent polys where you'd expect it to be ........

That was easy Grin

IP Logged

Pages: 1

‹ Previous Topic | Next Topic ›

« Home

‹ Board

Top of this page