It's relatively easy,

Example:

smoke.0 = -1.72, -23.29, -45.66, fx_smoke_effect  =smoke.0 = , , , fx_smoke_effect


Just change the values of X,Y,Z shown where the coordinates are to finalize your effects position.

Sorry the X,Y,Z represent positions 'in design terms' '

X= is length position Positive variable for forward and negative for aft position.

Y= needs to be moved side to side - is left + number is right

Z= Height negative value means lower positive means higher.

I don't understand your second question, other then if it's another effect just add smoke.1 then smoke.2 etc.

Woodylepic,

What aircraft are you working with? Because it is in the effects section like the touchdown and other effects, I suspect that the effect is coded to use the coordinates of the engine. These are located in the “General Engine Data” section of the aircraft cfg. If you have not already, you could try adding the numbers like mentioned above even if the other effects don’t have them. I don’t know if it will work but it might be worth a try.

Jon