Simviation Forum - Create Poly ?

	Search the archive:

Simviation Main Site | Site Search | Upload Images

Simviation Forum › Design Forums › Aircraft & 3D Design › Create Poly ?

(Moderators: Mitch., Fly2e, ozzy72, beaky, Clipper, JBaymore, Bob70, BigTruck)

‹ Previous Topic | Next Topic ›

Pages: 1

Create Poly ? (Read 212 times)

Jul 13^th, 2004 at 12:40am

hsvfan Offline
Colonel
I love YaBB 1G - SP1!
Wellington, New Zealand

Gender:
Posts: 262

Hi all,
Can someone tell me how to use the create poly. I have created an aircraft panel, but I neen to round it off at the back. I dont think I have a enough polys to make any changes to round of the panel

Cheers hsv

IP Logged

Reply #1 - Jul 15^th, 2004 at 8:39am

garymbuska Offline
Colonel
I would rather be flying
Jacksonville, Florida

Gender:
Posts: 2850

The best advice I can give is TUTE TUTE TUTE use the tutorials. It is a bit lengthy tyring to describe how to make a poly to use for a panel.

IP Logged

Reply #2 - Jul 15^th, 2004 at 9:33am

Milton Offline
Colonel
Props forever!

Gender:
Posts: 301

hsv,

An easier way may be to go into edge sub-object mode, select each top edge, then Divide. This breaks the edge into two pieces and creates the vertice you need to round off the top.

Hope this helps.

Milton&&Dash 7, Aero Commanders, Howard 500, D18S, Spartan, XP47J, Beechcraft A28 (Grizzly)

IP Logged

Pages: 1

‹ Previous Topic | Next Topic ›

« Home

‹ Board

Top of this page