Simviation Forum - help needed with after burners

	Search the archive:

Simviation Main Site | Site Search | Upload Images

Simviation Forum › Old Flight Simulator Series › FS 2002 › help needed with after burners

(Moderators: Mitch., Fly2e, ozzy72, beaky, Clipper, JBaymore, Bob70, BigTruck)

‹ Previous Topic | Next Topic ›

Pages: 1

help needed with after burners (Read 127 times)

May 30^th, 2004 at 5:56am

chosen1_2001 Offline
2nd Lieutenant
If your sitting here then
whos flying the plane?
London

Gender:
Posts: 1

Hi im using Fs2002 have a concorde uploaded but the gauges dnt work at all but iv got another panel in there..n e hows how do u activate the the after burners to reach mach 2? if u could let me know the key sequence thanks!!!

IP Logged

Reply #1 - May 30^th, 2004 at 8:10am

dave3cu Offline
Colonel
Procrastinate now, don't
put it off.
3CU, Northern Wisconsin, USA

Gender:
Posts: 3077

By default Shift+F4 activates afterburner. You can check your settings/controls/assignments/Engine commands to see if it is assigned.

Cheers,
Dave

At that time [1909] the chief engineer was almost always the chief test pilot as well. That had the fortunate result of eliminating poor engineering early in aviation. Igor Sikorsky

I intend to live forever....so far, so good. Steven Wright

You know....you can just rip up a to-do list.

IP Logged

Pages: 1

‹ Previous Topic | Next Topic ›

« Home

‹ Board

Top of this page