Some of the flight plans I've downloaded have "@" for the arrival times, I do not like using the a set arrival time, I'd rather TTools calculate the arrival time. My question is can you remove the "@" from the flight plan?
It is a weekly flight plan if that makes a difference.

Thank-you Lee Swordy for TTools & AFCAD, I use them daily....................

According to the notes with TTools 2.0 the compiler will automatically calculate the arrival time based on the departure time, distance, cruising speed, etc.  You may also specify an arrival time (preceded by the "@") and the compiler will calculate the departure time.
(Found on page 11 of 18 in the User Guide under LEG COMPONENT section.)
Bob

You can easily remove the arrival times. Typically, I'll change all the times to 00:00:00, which forces TTools to refigure it. To do this, I use Excel. Excel is good because it allows you to change en mass. Here's how-

1. Open Excel
2. Open the desired .txt file (you will have to tell Excel to search ALL files under FILES OF TYPE)
3. It will give you two choices. Delimited and Fixed Width. Make sure Delimited is selected and click NEXT.
4. The Delimiters menu will pop up next. Tab will be preselected. That is OK. Click COMMA and NEXT.
5. Click FINISH
6. Do your editing.

To Save.
1. On the FILE pull down menu, click SAVE AS
2. Put quotes around the file name and put a .txt at the end Ex "Flightplans.txt"
3. Click the pull down menu entitled SAVE AS TYPE
4. Drag down to CSV (Comma Delimited)
5. Click SAVE.

Hope that helps!