Search the archive:
YaBB - Yet another Bulletin Board
 
   
 
Page Index Toggle Pages: 1
Send Topic Print
Adding autopilot (Read 105 times)
Jul 25th, 2003 at 12:32pm

siemerh   Offline
Colonel
New Jersey

Gender: male
Posts: 88
*****
 
I have activated the autopilot in cfg of an add on aircraft and it works.  However there is no autopilot functions showing on the stack.  Can this be done so I can see what is active or not?  Also, GPS is there but again no switch shows.  Shocked ???
 

Where is it written?
IP Logged
 
Reply #1 - Jul 25th, 2003 at 12:38pm

ozzy72   Offline
Global Moderator
Pretty scary huh?
Madsville

Gender: male
Posts: 37122
*****
 
You have to add the switches to the panel or you won't see them. Go into the panel folder and open panel.cfg, and then add them, the two numbers after the button are its x and y co-ordinates on the panel.

Ozzy Wink
 

...
There are two types of aeroplane, Spitfires and everything else that wishes it was a Spitfire!
IP Logged
 
Reply #2 - Jul 25th, 2003 at 4:29pm

Lethal.Ambition   Offline
Colonel
They call me John.
Florida

Gender: male
Posts: 1563
*****
 
Ozzy, is there a tutorial for that lying around somewhere? I would love to check it out.
 

Oderint Dum Metuant - Let them hate as long as they fear.&&Proud member of the =XE= Xtreme Eagles&&Oderint Dum Metuant&&
IP Logged
 
Reply #3 - Jul 25th, 2003 at 6:05pm

Travis   Offline
Colonel
Cannot find REALITY.SYS.
Universe halted.
Dripping Springs, TX

Gender: male
Posts: 4515
*****
 
Go here

http://zone.msn.com/flightsim/FS02DevDeskSDK00.asp

and get the panels and gauges SDK.
 

...
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print