Simviation Forum - 737-800 Panel With Trinkets

	Search the archive:

Simviation Main Site | Site Search | Upload Images

Simviation Forum › Design Forums › Scenery & Panel Design › 737-800 Panel With Trinkets

(Moderators: Mitch., Fly2e, ozzy72, beaky, Clipper, JBaymore, Bob70, BigTruck)

‹ Previous Topic | Next Topic ›

Pages: 1

737-800 Panel With Trinkets (Read 1311 times)

Mar 25^th, 2012 at 11:39pm

BobF Offline
Colonel
I love YaBB 1G - SP1!
So. CA.

Gender:
Posts: 50

I downloaded and installed the 737-800 Panel with Trinkets by Skilaeb Dygsbi here today. There is no e-mail for Skilaeb. I get an error when trying to use the HUD. It says configuration error - Check your ini file. The entry in the panel.cfg is:

HUDCA$/config!config, 0,0,,, ./gauges/HUDCA$/B737config.ini

I don't know what this is as there is no HUDCA$/config gauge or any ini entry. Thanks, Bob.

IP Logged

Reply #1 - Mar 27^th, 2012 at 1:12am

Webb Offline
Colonel
Go 'Noles!
Morningwood Golf Resort

Posts: 1068

For now you can REM out that line by putting // in front of it. FS will ignore it.

// gauge40=HUDCA$/config!config, 0,0,,, ./gauges/HUDCA$/B737config.ini

A bad day at golf is better than a good day at work.

Jim

IP Logged

Reply #2 - Mar 27^th, 2012 at 1:32am

BobF Offline
Colonel
I love YaBB 1G - SP1!
So. CA.

Gender:
Posts: 50

Hi. Thanks. If I rem it out will the HUD work OK? Regards, Bob.

IP Logged

Reply #3 - Mar 27^th, 2012 at 1:41am

Webb Offline
Colonel
Go 'Noles!
Morningwood Golf Resort

Posts: 1068

Everything should work the same as it does now but without the error message. That line of code isn't doing anything anyway.

I didn't install the panel. I just downloaded it and examined the code. It's a pretty obvious mistake.

A bad day at golf is better than a good day at work.

Jim

IP Logged

Reply #4 - Mar 27^th, 2012 at 11:17am

BobF Offline
Colonel
I love YaBB 1G - SP1!
So. CA.

Gender:
Posts: 50

HI. OK. Thanks. I'll try it. Regards, Bob.

IP Logged

Reply #5 - Mar 27^th, 2012 at 3:30pm

BobF Offline
Colonel
I love YaBB 1G - SP1!
So. CA.

Gender:
Posts: 50

Webb wrote on Mar 27^th, 2012 at 1:41am:

Hi. Thanks. I deleted that line and renumbered the gauges so they were in order. When I try the HUD I get the same error about the config ini. Any help sure would be appreciated. If anyone knows how to contact the author I'd like to know how. Bob.

IP Logged

Pages: 1

‹ Previous Topic | Next Topic ›

« Home

‹ Board

Top of this page