I downloaded and installed the 737-800 Panel with Trinkets by Skilaeb Dygsbi here today. There is no e-mail for Skilaeb. I get an error when trying to use the HUD. It says configuration error - Check your ini file. The entry in the panel.cfg is:

HUDCA$/config!config, 0,0,,, ./gauges/HUDCA$/B737config.ini

I don't know what this is as there is no HUDCA$/config gauge or any ini entry. Thanks, Bob.

For now you can REM out that line by putting // in front of it.  FS will ignore it.

// gauge40=HUDCA$/config!config, 0,0,,, ./gauges/HUDCA$/B737config.ini

Hi. Thanks. If I rem it out will the HUD work OK? Regards, Bob.

Everything should work the same as it does now but without the error message.  That line of code isn't doing anything anyway.

I didn't install the panel.  I just downloaded it and examined the code.  It's a pretty obvious mistake.

HI. OK. Thanks. I'll try it. Regards, Bob.

Webb wrote on Mar 27^th, 2012 at 1:41am:

Everything should work the same as it does now but without the error message.  That line of code isn't doing anything anyway. I didn't install the panel.  I just downloaded it and examined the code.  It's a pretty obvious mistake.

Hi. Thanks. I deleted that line and renumbered the gauges so they were in order. When I try the HUD I get the same error about the config ini. Any help sure would be appreciated. If anyone knows how to contact the author I'd like to know how. Bob.