Search the archive:
YaBB - Yet another Bulletin Board
 
   
 
Page Index Toggle Pages: 1
Send Topic Print
Leaned descent (Read 1181 times)
Jul 3rd, 2003 at 8:45am

Ivan   Offline
Colonel
No, I'm NOT Russian, I
only like Russian aircraft
The netherlands

Gender: male
Posts: 6058
*****
 
If you descend from a high altitude with engine leaned, do you use throttle or mixture for setting RPM's on a fixed-pitch propellor
 

Russian planes: IL-76 (all standard length ones),  Tu-154 and Il-62, Tu-134 and An-24RV&&&&AI flightplans and repaints can be found here
IP Logged
 
Reply #1 - Jul 3rd, 2003 at 1:43pm

ozzy72   Offline
Global Moderator
Pretty scary huh?
Madsville

Gender: male
Posts: 37122
*****
 
You should enrich the mixture at lower altitudes or you can have the engine stop....... Embarrassed

Ozzy
 

...
There are two types of aeroplane, Spitfires and everything else that wishes it was a Spitfire!
IP Logged
 
Reply #2 - Jul 3rd, 2003 at 1:59pm

Fozzer   Offline
Colonel
An elderly FS 2004 addict!
Hereford. England. EGBS.

Posts: 24861
*****
 
...and if you have the throttle closed, don't forget to apply carburettor heat, (if you have a normally aspirated engine), or the carb(s) will ice up and the engine will stop....
Cancel carb heat, and make sure that the mixture is rich, just before landing, just in case you need full power to "go around" or "missed approach", or if you are doing "touch-and go's"... Wink...!

Cheers... Grin...!
Paul.
(England).
 

Dell Dimension 5000 BTX Tower. Win7 Home Edition, 32 Bit. Intel Pentium 4, dual 2.8 GHz. 2.5GB RAM, nVidia GF 9500GT 1GB. SATA 500GB + 80GB. Philips 17" LCD Monitor. Micronet ADSL Modem only. Saitek Cyborg Evo Force. FS 2004 + FSX. Briggs and Stratton Petrol Lawn Mower...Motor Bikes. Gas Cooker... and lots of musical instruments!.... ...!
Yamaha MO6,MM6,DX7,DX11,DX21,DX100,MK100,EMT10,PSR400,PSS780,Roland GW-8L v2,TR505,Casio MT-205,Korg CX3v2 dual manual,+ Leslie 760,M-Audio Prokeys88,KeyRig,Cubase,Keyfax4,Guitars,Orchestral,Baroque,Renaissance,Medieval Instruments.
IP Logged
 
Reply #3 - Jul 4th, 2003 at 3:41am

Ivan   Offline
Colonel
No, I'm NOT Russian, I
only like Russian aircraft
The netherlands

Gender: male
Posts: 6058
*****
 
To explain it somewhat better...
...
At position 1, i'm at 11000 ft altitude, going some 110Kts at around 2000 rpm and leaned for maximum RPM

At position 2, near the PR NDB, I throttle back to 1500 RPM, mixture stays the same

At position 3 I begin the descent  (FIX 13 is around 8000 ft)
When descending in the turn, i can decrease RPM in 2 different ways: by adjusting the throttle or by adjusting mixture.
When i change the throttle, i need to increase throttle again near FIX 17, to keep the RPM constant when entering the glideslope.
When i use the mixture, i don't have to increase throttle to keep the RPM constant from position 2 on. Only in the glideslope i have to adjust the throttle

The aircraft i use is the Il-103, somewhat strange modelled in FS, because it starts to waggle 20Kts from the maximum published cruise speed and is able to fly some 2000ft higher than published.
It has a fixed pitch prop, and 200hp engine power
 

Russian planes: IL-76 (all standard length ones),  Tu-154 and Il-62, Tu-134 and An-24RV&&&&AI flightplans and repaints can be found here
IP Logged
 
Reply #4 - Sep 25th, 2003 at 11:46pm

MattNW   Offline
Colonel
Indiana

Gender: male
Posts: 1762
*****
 
From a mechanical standpoint I'd say you'd use the throttle since by using the mixture you will either have to lean it out or enrich the mixture so that you decrease the performance of the engine.

If you run it too lean you stand a chance of overheating the engine and if you run it too rich you could foul a plug and not have full power if you need it. By using the throttle with the mixture set where it should be for whatever altitude you are flying you wouldn't have these problems.
 

In Memory of John Consterdine (FS Tipster)1962-2003
IP Logged
 
Reply #5 - Sep 26th, 2003 at 9:27pm

OTTOL   Offline
Colonel
Fintas, Kuwait (OKBK)

Gender: male
Posts: 918
*****
 
Seems like we're using a Bulldozer when we need a shovel!  Lips Sealed Roll Eyes Cheesy Cheesy Quote:
  do you use throttle or mixture for setting RPM's on a fixed-pitch propellor



                  Throttle! 



................richen as you descend-if you have a CHT(cylinder head temperature) gage, or an EGT(Exhaust gas temperature) gage use them. If the Aircraft doesn't have these, chances are, it's not a very "high performance" aircraft, in which case, I would just richen at the beginning of the descent.  Wink
« Last Edit: Sep 26th, 2003 at 11:19pm by OTTOL »  

.....so I loaded up the plane and moved to Middle-EEEE..........OIL..that is......
IP Logged
 
Reply #6 - Nov 6th, 2003 at 11:13pm

Aces-High   Offline
Colonel
I love YaBB 1G - SP1!

Posts: 11
*****
 
A leaned mixture can either increase RPM or drastically decrease RPM (i.e. the engine stops)  If you descend with a leaned mixture you run the risk of losing the engine as there is too much air and not enough fuel going to the cylinders.  Fuel needs a specific amound of air and fuel in order to burn. 
However, if you are flying at high altitudes without a leaned out mixture then you will have too much fuel and not enough air and the fuel will not burn as efficiently which will cause a reduction in RPM.  In this case leaning the mixture will increase engine RPM.
 
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print