Search the archive:
 YaBB - Yet another Bulletin Board
 
   
 
  Simviation Forum › Design Forums › Aircraft & 3D Design › Nosegear bay
(Moderators: Mitch., Fly2e, ozzy72, beaky, Clipper, JBaymore, Bob70, BigTruck)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1
Send Topic Print
Nosegear bay (Read 589 times)
Feb 24th, 2003 at 11:46am

ajver   Offline
Colonel
I love YaBB 1G - SP1!

Posts: 224
 *****
 
How do I cut a nosegear bay in the fuselage.  I am not sure that the tutorial by Mike Crosthwaite for 3-D landing gear bays in the wings will work.
 
Back to top 
IP Logged
 
Reply #1 - Feb 24th, 2003 at 11:57am

JohnP   Offline
Colonel
I love YaBB 1G - SP1!

Posts: 182
 *****
 
SmileyThe tutorial that you refer to will work. The principles are the same I have used it with success on some of my planes, that I do in FSFS2.11. You might have to be a little flexible, but with a little experimentation, it will work.
  Good Luck. Smiley
 
Back to top 
IP Logged
 
Reply #2 - Feb 24th, 2003 at 2:09pm

ajver   Offline
Colonel
I love YaBB 1G - SP1!

Posts: 224
 *****
 
Thank you JohnP.  As long as I know it did work on your aircraft, I will start experimenting.
 
Back to top 
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print
‹ Previous Topic | Next Topic ›
  « Home ‹ Board Top of this page

Simviation Forum » Powered by YaBB 2.5 AE!
YaBB Forum Software © 2000-2010. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge