Search the archive:
 YaBB - Yet another Bulletin Board
 
   
 
  Simviation Forum › Current Flight Simulator Series › Adding Aircraft Traffic (AI) & Gates › New flight plans, paints don't show
(Moderators: Mitch., Fly2e, ozzy72, beaky, Clipper, JBaymore, Bob70, BigTruck)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1
Send Topic Print
New flight plans, paints don't show (Read 936 times)
Feb 14th, 2013 at 9:26pm

Capt._Viper   Offline
Colonel
Turning and Burning the
40's Way.
NC, United States

Gender: male
 Posts: 162
 *****
 
I created some flight plans for KFFO in FS9. They where made bby copying exsisting plan elements, where everything shows as it is suspose to. But now the A/C show up without their paints. Any thoughts?
 
Back to top 
IP Logged
 
Reply #1 - Feb 15th, 2013 at 5:42pm

tgibson   Offline
Colonel
I Like Flight Simulation!
San Diego, CA

Gender: male
 Posts: 117
 *****
 
I assume these are liveries that have shown up OK before?  If your video card and/or CPU are under stress, AI can appear without their textures.  Perhaps you added too many?

If these are new liveries you added for these new flight plans and you are *sure* that the texture= lines are correct, then if you are using Vista/Win7/8 and your FS installation is located in a Program Files folder, then I have heard of this happening.  Turning UAC off (temporarily) is a good test to check this.

Hope this helps,
 
---
Tom Gibson
CalClassic Propliner Page
http://www.calclassic.com
Back to top 
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print
‹ Previous Topic | Next Topic ›
  « Home ‹ Board Top of this page

Simviation Forum » Powered by YaBB 2.5 AE!
YaBB Forum Software © 2000-2010. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge