Simviation Forum - adding paved areas...

	Search the archive:

Simviation Main Site | Site Search | Upload Images

Simviation Forum › Design Forums › Scenery & Panel Design › adding paved areas...

(Moderators: Mitch., Fly2e, ozzy72, beaky, Clipper, JBaymore, Bob70, BigTruck)

‹ Previous Topic | Next Topic ›

Pages: 1

adding paved areas... (Read 508 times)

Apr 15^th, 2011 at 4:03pm

Groundbound1 Offline
Colonel
No, I don't work for Mythbusters...
Michigan, USA

Gender:
Posts: 1745

What would be the easiest utility to use to add paved areas in and around an airport. (like driveways, roads, parking lots etc)

Specs: Asus Crosshair nForce 590 SLI,
AMD Athlon X2 6400+ w/ZeroTherm BTF90,
4GB G.Skill PI Series DDR2-800,
Sapphire HD4870 512MB,
PC P&C 750 Quad, in a CoolerMaster HAF932

IP Logged

Reply #1 - Apr 15^th, 2011 at 6:51pm

dave3cu Offline
Colonel
Procrastinate now, don't
put it off.
3CU, Northern Wisconsin, USA

Gender:
Posts: 3077

You don't say which sim..these are what I use..

FS9-If the area is flat and level with the airport you can use Afcad or ADE taxiways and aprons. If not, then SBuilder v1.05 rev 6 to draw textured lines and polys.

For FSX-ADE for taxiways and aprons and it can also do textured lines and polys in FSX. Or SBuilderX.

ADE-http://www.airportdesigneditor.co.uk/ade_003.htm

Sbuilder for FS2004 or FSX-http://www.ptsim.com/index.php?option=com_content&view=category&layout=blog&id=4...

At that time [1909] the chief engineer was almost always the chief test pilot as well. That had the fortunate result of eliminating poor engineering early in aviation. Igor Sikorsky

I intend to live forever....so far, so good. Steven Wright

You know....you can just rip up a to-do list.

IP Logged

Reply #2 - Apr 16^th, 2011 at 8:16am

Groundbound1 Offline
Colonel
No, I don't work for Mythbusters...
Michigan, USA

Gender:
Posts: 1745

Sorry, I should have mentioned it was for FS9. Thanks Dave! I'll give them a go!

Specs: Asus Crosshair nForce 590 SLI,
AMD Athlon X2 6400+ w/ZeroTherm BTF90,
4GB G.Skill PI Series DDR2-800,
Sapphire HD4870 512MB,
PC P&C 750 Quad, in a CoolerMaster HAF932

IP Logged

Reply #3 - Apr 16^th, 2011 at 1:44pm

Groundbound1 Offline
Colonel
No, I don't work for Mythbusters...
Michigan, USA

Gender:
Posts: 1745

ADE is perfect! Just what I was looking for. Thanks again!

Specs: Asus Crosshair nForce 590 SLI,
AMD Athlon X2 6400+ w/ZeroTherm BTF90,
4GB G.Skill PI Series DDR2-800,
Sapphire HD4870 512MB,
PC P&C 750 Quad, in a CoolerMaster HAF932

IP Logged

Pages: 1

‹ Previous Topic | Next Topic ›

« Home

‹ Board

Top of this page