Simviation Forum - FS9 Saitek Throttle Quadrant problem

	Search the archive:

Simviation Main Site | Site Search | Upload Images

Simviation Forum › Computer Hardware & Software Forum › Hardware › FS9 Saitek Throttle Quadrant problem

(Moderators: Mitch., Fly2e, ozzy72, beaky, Clipper, JBaymore, Bob70, BigTruck)

‹ Previous Topic | Next Topic ›

Pages: 1

FS9 Saitek Throttle Quadrant problem (Read 328 times)

Jun 6^th, 2010 at 9:04pm

flaminghotsauce Offline
Colonel
I love YaBB 1G - SP1!

Posts: 181

I just reinstalled FS9 for fun. I have a Saitek yoke and throttle quadrant, with the second quadrant. I run it left to right as throttle one, two, prop one, two, and mix one, and two.

In FS9 the prop one lever will not respond. I have set it, double checked to make sure I was editing the correct quadrant, etc. and cannot make it go. All the other functions of the setup work perfectly.

To double check, I fired up FSX, and all works perfectly. The "Y" axis on the yoke quadrant simply refuses to go under FS9 but works perfectly under FSX.... Huh

Any ideas? Any help appreciated!

IP Logged

Reply #1 - Jun 6^th, 2010 at 11:29pm

Groundbound1 Offline
Colonel
No, I don't work for Mythbusters...
Michigan, USA

Gender:
Posts: 1745

I dunno, tried deleting the FS9.cfg and letting the sim rebuild a new one? Undecided

Specs: Asus Crosshair nForce 590 SLI,
AMD Athlon X2 6400+ w/ZeroTherm BTF90,
4GB G.Skill PI Series DDR2-800,
Sapphire HD4870 512MB,
PC P&C 750 Quad, in a CoolerMaster HAF932

IP Logged

Reply #2 - Jun 7^th, 2010 at 4:42pm

flaminghotsauce Offline
Colonel
I love YaBB 1G - SP1!

Posts: 181

Eeeehhh, no. I guess I could try. It's a fresh install of FS9.

IP Logged

Pages: 1

‹ Previous Topic | Next Topic ›

« Home

‹ Board

Top of this page