Search the archive:
YaBB - Yet another Bulletin Board
 
   
 
Page Index Toggle Pages: 1
Send Topic Print
Stumbling block (Read 310 times)
Oct 2nd, 2009 at 6:09pm

olderndirt   Offline
Colonel
Flying is PFM
Rochester, WA

Gender: male
Posts: 3574
*****
 
Using "Rivatuner" to set up a fan speed profile for my video card and encountered a problem in the 'launcher tab' section.  I reach the 'Regular item editor' window and it's too tall for my 1440x900 screen.  Since I need to start at the very top and end at the bottom, I'm stuck.  Is there a solution to this?
 

... 

                            
THIS IS NOT A PANAM CLIPPER

                                                            
IP Logged
 
Reply #1 - Oct 2nd, 2009 at 7:32pm

NickN   Offline
Colonel
FSX runs fine... the problem
is you or your system

Posts: 6317
*****
 


Im not sure what the problem is.. but you would probably be better served going over the the rivatuner forum and posting this..

they have changes in their different RT versions for different driver support and since the revsions can work different for different cards you would be far better off getting an answer from them than here

Make sure you specify the revsion of RT you are using, the driver in use and the video card model


 
IP Logged
 
Reply #2 - Oct 2nd, 2009 at 9:57pm

olderndirt   Offline
Colonel
Flying is PFM
Rochester, WA

Gender: male
Posts: 3574
*****
 
Thanks Nick.
 

... 

                            
THIS IS NOT A PANAM CLIPPER

                                                            
IP Logged
 
Reply #3 - Oct 4th, 2009 at 4:51pm

Plugpennyshadow   Offline
Colonel
Hello!

Gender: male
Posts: 276
*****
 
Why adjust the speed of the fan on a video card?  Is it not running at full speed already or is the goal to slow the fan down?

Curiosity and all that...
 
IP Logged
 
Reply #4 - Oct 4th, 2009 at 4:57pm

Plugpennyshadow   Offline
Colonel
Hello!

Gender: male
Posts: 276
*****
 
I would prefer the fans to run at top speed.  The vid card fan is buried too deep in the system for my to hear it and I have just learned to tune out the case fans.  They are louder than some I have heard but pull MUCHO heat out of my system.

Im running a stock Intel cooler right now as my Thermaltake poopered out on me.  Failure might have had something to do with the cat knocking it off the table, but what would I know.

Running four 120mm fans at whatever rpms they run at simply plugged into the mobo and system is quite cool.  Maybe a little over-cool?
 
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print