Simviation Forum - Deleteing Trees

	Search the archive:

Simviation Main Site | Site Search | Upload Images

Simviation Forum › Design Forums › Scenery & Panel Design › Deleteing Trees

(Moderators: Mitch., Fly2e, ozzy72, beaky, Clipper, JBaymore, Bob70, BigTruck)

‹ Previous Topic | Next Topic ›

Pages: 1

Deleteing Trees (Read 431 times)

Jan 23^rd, 2009 at 4:06pm

specter177 Offline
Colonel
Check out the Maverick
Flying Car!
I-TEC - X35

Gender:
Posts: 1406

Is there a way to take out trees in a certain area of FSX?

IP Logged

Reply #1 - Jan 23^rd, 2009 at 7:38pm

skoker Offline
Colonel
Jordan never wore his
safety goggles...
1G3

Gender:
Posts: 4611

Take an AFCAD program and put an exclusion rectangle over the unwanted trees. Don't forget to put a checkmark on the trees box

IP Logged

Reply #2 - Jan 23^rd, 2009 at 8:14pm

specter177 Offline
Colonel
Check out the Maverick
Flying Car!
I-TEC - X35

Gender:
Posts: 1406

Yea, I'm using Airport Design Editor, but I don't see a tree checkmark for the exclusions area.

IP Logged

Reply #3 - Jan 23^rd, 2009 at 8:42pm

dave3cu Offline
Colonel
Procrastinate now, don't
put it off.
3CU, Northern Wisconsin, USA

Gender:
Posts: 3077

I believe that in ADE, you can create a terrain polygon and specify properties for the polygon that will remove the autogen trees.

Here is a topic in the ADE support forum at FSDeveloper.com that discusses the issue. http://www.fsdeveloper.com/forum/showthread.php?t=10647&highlight=remove+autogen

Dave

At that time [1909] the chief engineer was almost always the chief test pilot as well. That had the fortunate result of eliminating poor engineering early in aviation. Igor Sikorsky

I intend to live forever....so far, so good. Steven Wright

You know....you can just rip up a to-do list.

IP Logged

Reply #4 - Jan 23^rd, 2009 at 11:06pm

specter177 Offline
Colonel
Check out the Maverick
Flying Car!
I-TEC - X35

Gender:
Posts: 1406

Thanks.

IP Logged

Reply #5 - Jan 25^th, 2009 at 6:04am

Scruffyduck Offline
Colonel

Posts: 164

In FSX (unlike FS9) you cannot remove autogen trees using an exclusion rectangle. To do this you need a terrain exclusion. You are correct that ADE can do this. It can also be done using SBuilderX or FSX KML

Jon&&Microsoft Flight Sim MVP&&------&&www.airportdesigneditor.co.uk&&www.scruffyduck.org.uk/scenery&&www.fsdeveloper.com

IP Logged

Pages: 1

‹ Previous Topic | Next Topic ›

« Home

‹ Board

Top of this page