Simviation Forum - Saitek Cyborg 3D Force

	Search the archive:

Simviation Main Site | Site Search | Upload Images

Simviation Forum › Computer Hardware & Software Forum › Hardware › Saitek Cyborg 3D Force

(Moderators: Mitch., Fly2e, ozzy72, beaky, Clipper, JBaymore, Bob70, BigTruck)

‹ Previous Topic | Next Topic ›

Pages: 1

Saitek Cyborg 3D Force (Read 217 times)

Oct 13^th, 2008 at 3:58pm

George7 Offline
Colonel
Fly FS

Posts: 11

My stick's throttle checks out OK in FS2004 calibration and it's action shows up normal on the monitor. I stick throttle is inoperative when connected to any given A/C.

Any ideas? It wasn't this way until recently.

George7

IP Logged

Reply #1 - Oct 13^th, 2008 at 10:19pm

dave3cu Offline
Colonel
Procrastinate now, don't
put it off.
3CU, Northern Wisconsin, USA

Gender:
Posts: 3077

Have you checked the Setting>Controls>Assignments>Joystick Axes tab to make sure it is still assigned properly?

At that time [1909] the chief engineer was almost always the chief test pilot as well. That had the fortunate result of eliminating poor engineering early in aviation. Igor Sikorsky

I intend to live forever....so far, so good. Steven Wright

You know....you can just rip up a to-do list.

IP Logged

Pages: 1

‹ Previous Topic | Next Topic ›

« Home

‹ Board

Top of this page