Search the archive:
 YaBB - Yet another Bulletin Board
 
   
 
  Simviation Forum › Current Flight Simulator Series › Flight Simulator X › Autopilot Altitude Set
(Moderators: Mitch., Fly2e, ozzy72, beaky, Clipper, JBaymore, Bob70, BigTruck)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1
Send Topic Print
Autopilot Altitude Set (Read 245 times)
Aug 31st, 2007 at 5:58am

thomasnc41   Offline
Lieutenant Colonel
I Fly Sim!
Hope Mills, NC

Gender: male
 Posts: 5
 *****
 
I have a problem with the auto pilot altitude setting.  I originally could set the altitude in increments of 100 ft.  For some reason the altitude set will only set in increments of 1000 ft. 

How do I set the default back to 100 ft?????


Thanks, Tom
 
Acer X243W  24" Monitor&&ASUS P5N-E SLI Motherboard&&Intel Core 2 Duo E6470 (Conroe) 2.33GHz&&NVIDIA GeForce 8600 GT  256 MB memory X 2&&3 Gig DD2RAM DIMM Speed 800MHz &&300 Gig SATA HDD &&500 Gig SATA HDD&&Microsoft Vista Home 32 bit &&Logitech Extreme 3D Pro
Back to top 
IP Logged
 
Reply #1 - Aug 31st, 2007 at 9:35am

garymbuska   Offline
Colonel
I would rather be flying
Jacksonville, Florida

Gender: male
 Posts: 2850
 *****
 
thomasnc41 wrote on Aug 31st, 2007 at 5:58am:
I have a problem with the auto pilot altitude setting.  I originally could set the altitude in increments of 100 ft.  For some reason the altitude set will only set in increments of 1000 ft.  

How do I set the default back to 100 ft?????


Thanks, Tom

Have you added any new gauges lately. I have seen this happen before and it was a result of a gauge being repalced. 
One has to be carefull when adding gauges. It is usually a good idea not to over write any existing gauge.

If you open the panel cfg file for the airplane with the problem you can find out which gauge it is using for the altitude indicator. Then it is just a matter of finding the correct gauge to replace it with. If the aircraft is using a default planes panel then you can find the gauge on DISK 1 of the install CD'S Cool
 
Back to top 
IP Logged
 
Reply #2 - Aug 31st, 2007 at 2:23pm

Nigel©   Offline
Colonel
Leaving on a jet plane...
CYQM

Gender: male
 Posts: 536
 *****
 
If you in an Airbus there should be two little numbers above the altimeter knob. 100 and 1000. Click just below and it should change back to 100. (That is if your in a bus)   Wink
 
Learning to fly, but I ain't got wings...
Back to top 
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print
‹ Previous Topic | Next Topic ›
  « Home ‹ Board Top of this page

Simviation Forum » Powered by YaBB 2.5 AE!
YaBB Forum Software © 2000-2010. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge