Search the archive:
 YaBB - Yet another Bulletin Board
 
   
 
  Simviation Forum › Design Forums › Scenery & Panel Design › AFCAD
(Moderators: Mitch., Fly2e, ozzy72, beaky, Clipper, JBaymore, Bob70, BigTruck)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1
Send Topic Print
AFCAD (Read 441 times)
Aug 17th, 2007 at 7:24pm

colsie123   Offline
Colonel
Glasgow

Gender: male
 Posts: 215
 *****
 
Can someone tell me how you make a brnad new non exicstent airport in AFCAD and also the lattitude and longtitude for it and a link to the latest version please my version is 44 months old.
 
Join my VA go on
Back to top 
IP Logged
 
Reply #1 - Aug 17th, 2007 at 8:05pm

dave3cu   Offline
Colonel
Procrastinate now, don't
put it off.
3CU, Northern Wisconsin, USA

Gender: male
 Posts: 3077
 *****
 
Don't worry about the 'your version is XX months old.....', it just pops up now and then. The version (2.21) in the SimV downloads is the latest.

To start a new airport: Read the User Manual, 'Readme.htm', that is included.

Section 52. Creating a New Airport From Scratch

Dave

 
At that time [1909] the chief engineer was almost always the chief test pilot as well. That had the fortunate result of eliminating poor engineering early in aviation.          Igor Sikorsky

I intend to live forever....so far, so good.         Steven Wright

You know....you can just rip up a to-do list.
Back to top 
IP Logged
 
Reply #2 - Aug 18th, 2007 at 5:42am

colsie123   Offline
Colonel
Glasgow

Gender: male
 Posts: 215
 *****
 
Hey thanks a lot ill give that manual a good looking at sometime.  Grin
 
Join my VA go on
Back to top 
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print
‹ Previous Topic | Next Topic ›
  « Home ‹ Board Top of this page

Simviation Forum » Powered by YaBB 2.5 AE!
YaBB Forum Software © 2000-2010. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge