Search the archive:
YaBB - Yet another Bulletin Board
 
   
 
Page Index Toggle Pages: 1
Send Topic Print
landing problem (Read 840 times)
Feb 5th, 2007 at 2:09pm

captjim   Offline
Colonel
I love YaBB 1G - SP1!

Posts: 116
*****
 
CryHi fellow simmers, captjim here again,

     New problem.  This recently started and is problem in fs9 and 2002.  Whenever I get lined up with the runway for landing, my plane starts to yaw to the right or left of the center line.  I have done all the required things, slowed speed and rate of decent etc.  However, I end up on either side of the runway.  Even if I use "autorudder" or not.  Any suggestions.  By the way I have calibrated the joystick.  Thanks, captjim


 
IP Logged
 
Reply #1 - Feb 5th, 2007 at 3:35pm

ozzy72   Offline
Global Moderator
Pretty scary huh?
Madsville

Gender: male
Posts: 37122
*****
 
Are you using a prop driven aircraft? Then it would be torque.
 

...
There are two types of aeroplane, Spitfires and everything else that wishes it was a Spitfire!
IP Logged
 
Reply #2 - Feb 5th, 2007 at 11:03pm

captjim   Offline
Colonel
I love YaBB 1G - SP1!

Posts: 116
*****
 
Embarrassed Usually jets, but on occassion props also.  I'll just have to work with it and see if I can get it to work right.  I could be in the microsoft forcefeed back stick.  as I indicated is did test the sensitivities and calbriated it.  I wounder if the auito rudder is the problem.  most likely it's old captjim just losing his touch.  thanks Undecided
 
IP Logged
 
Reply #3 - Feb 12th, 2007 at 1:30pm

SimulatorFun10   Offline
Colonel
I Fly Sim!

Posts: 12
*****
 
Have you looked at the Throttle Qaudrant? if not turn it on and is one lever higher than the other if so theres your problem. If not then i dont know what it is. Crosswinds? Rudder?
 
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print