Simviation Forum - Can't Switch Between AFCAD and FS2002

	Search the archive:

Simviation Main Site | Site Search | Upload Images

Simviation Forum › Current Flight Simulator Series › Adding Aircraft Traffic (AI) & Gates › Can't Switch Between AFCAD and FS2002

(Moderators: Mitch., Fly2e, ozzy72, beaky, Clipper, JBaymore, Bob70, BigTruck)

‹ Previous Topic | Next Topic ›

Pages: 1

Can't Switch Between AFCAD and FS2002 (Read 155 times)

Apr 22^nd, 2005 at 4:18am

fsjeffrey Offline
Colonel
I love YaBB 1G - SP1!

Posts: 74

I just started learning AFCAD today. I didn't get very far though. On page 13 of the Version 1.4 User Manual
I followed the instructions in Section 14 "Slewing in Flight Simulator."

My problem is that I can't seem to go from FS to the AFCAD window by using the Ctrl+tab keys.

I accessed AFCAD.exe and got an airport. With AFCAD open on the screen I brought up FS2002 and created a flight using the same airport as the one in AFCAD.

I went into slew mode and top-down view and hit ctrl+tab and nothing happened. I couldn't go from FS to AFCAD.

I checked Control---Assignments and ctrl+tab is shown as "switch to next view."

FSUIPC is in my FS Modules folder.

Even went to AFCAD view and checked "Lock to Flightsim."

It's pretty discouraging getting stumped this early.

What am I doing wrong?

IP Logged

Reply #1 - Apr 24^th, 2005 at 11:47pm

dave3cu Offline
Colonel
Procrastinate now, don't
put it off.
3CU, Northern Wisconsin, USA

Gender:
Posts: 3077

I think 'Alt+Tab' is what your looking for (Windows task switch).

Or run FS2002 in 'windowed' mode, 'Alt+Enter' and you can switch from the 'task bar'.

Dave

At that time [1909] the chief engineer was almost always the chief test pilot as well. That had the fortunate result of eliminating poor engineering early in aviation. Igor Sikorsky

I intend to live forever....so far, so good. Steven Wright

You know....you can just rip up a to-do list.

IP Logged

Pages: 1

‹ Previous Topic | Next Topic ›

« Home

‹ Board

Top of this page