Simviation Forum - GMAX error

	Search the archive:

Simviation Main Site | Site Search | Upload Images

Simviation Forum › Design Forums › Aircraft & 3D Design › GMAX error

(Moderators: Mitch., Fly2e, ozzy72, beaky, Clipper, JBaymore, Bob70, BigTruck)

‹ Previous Topic | Next Topic ›

Pages: 1

GMAX error (Read 155 times)

Mar 10^th, 2005 at 1:35pm

Akula. Offline
Colonel
o.O
UK

Gender:
Posts: 943

I downloaded GMAX, started it up, and typed in the reg key. I was expecting it to load GMAX, but instead it did this:

Swift response would be appreciated, cos i'm designing a game and I cant afford to lose much time...

Thanks in advance,

Akula

EDIT: sorry about the pic, i dont know why but it wouldnt resize without going pitch black...

- Akula

IP Logged

Reply #1 - Mar 10^th, 2005 at 1:49pm

Felix/FFDS Offline
Admin
FINALLY an official Granddad!
Orlando, FL

Gender:
Posts: 1000000627

On the picture - All you needed to do was to crop the important part, not necessarily resize.

(Note - I did the cropping and uploading - 2 minutes total)

Probably some setting in your video setup changed.

Do a START->RUN then type in COMMAND in the box.

in the command line screen (or DOS screen); type in

C:\gmax\gmax.exe -h

then in Customize-> Preferences, either reset your video driver options, or use the heidi (software) driver.

Felix/FFDS

IP Logged

Reply #2 - Mar 10^th, 2005 at 1:55pm

Akula. Offline
Colonel
o.O
UK

Gender:
Posts: 943

Ahhh!
I could kiss you! (although I wont because you would probably sue me

)
Sorry for being so un-informative, but i was almost pulling teeth. I'm trying to write a 1st-person shooter about the sniper-dual between Vassili Zaitsev and Major Keonig in Stalingrad, and I'm animating everything in GMAX because I cant figure out animations in FSDS. I'm trying to get the 1st level of the game ready for demos by easter (probably wont happen) and so I panicked. Thanks for the advice, it's working good now!

Akula

- Akula

IP Logged

Reply #3 - Mar 10^th, 2005 at 3:12pm