Simviation Forum - Flatten Switch

	Search the archive:

Simviation Main Site | Site Search | Upload Images

Simviation Forum › Current Flight Simulator Series › Adding Aircraft Traffic (AI) & Gates › Flatten Switch

(Moderators: Mitch., Fly2e, ozzy72, beaky, Clipper, JBaymore, Bob70, BigTruck)

‹ Previous Topic | Next Topic ›

Pages: 1

Flatten Switch (Read 208 times)

Jan 17^th, 2005 at 9:45pm

chuboy Offline
Colonel
Nothing is nothing
Australia

Gender:
Posts: 14

I created an airport. After using the flatten switch to ensure the terrain would be at the right height, I excluded all default objects from the area. I checked in FS2004, and no airport! Is the new airport still classed as a default object? I deleted the exclude switch and the airport reappeared, along with trees and autogen buildings. Any suggestions? ???

Ultimate cryptologist.&&&&Nothing are your thoughts worth to a worthless mind, yet nothing is worthless to thoughtful mind.&&&&To avoid mistakes, you must gain experience.&&To gain experience, you must make mistakes.

IP Logged

Reply #1 - Jan 18^th, 2005 at 9:02am

garymbuska Offline
Colonel
I would rather be flying
Jacksonville, Florida

Gender:
Posts: 2850

I think what you may have done was to put the flatten switch in the wrong place. What I mean is when you made your airport and added it to your scenery it made a entry in your scenery cfg file. Usually it is the last entry in the file if you put the exclude switch in this line then you just erased what you did. Wht you need to to is to find the area the old airport is in and put the exclude in that area.
Example
(area 3)
local= scenery/neam
remote=0
If this is the area the old airport is in then put the exclude switch here
Do not put it in the same area as you new scenery is in 8)

IP Logged

Pages: 1

‹ Previous Topic | Next Topic ›

« Home

‹ Board

Top of this page