Search the archive:
YaBB - Yet another Bulletin Board
 
   
 
Page Index Toggle Pages: 1
Send Topic Print
Help with B-52 panel (Read 195 times)
Dec 13th, 2004 at 5:52am

AlphaBravo   Offline
Colonel
Alpha and Badger ....hehehehe
Reading, Berkshire, UK

Gender: female
Posts: 1050
*****
 
hi all i have had 2k2 for a while and decided to download sum more planes. i got quite a few and they all work fine. i then downloaded the b-52 and the panel for it i think i put the panel in the right place. the problem is that the panel shows up but none of the gauges show up there are just empty bits where there surpose to be. Can any one help me??

AlphaBravo
 

...
&&
Add me to xfire: alphabravo0sw
IP Logged
 
Reply #1 - Dec 13th, 2004 at 6:02am

Hagar   Offline
Colonel
My Spitfire Girl
Costa Geriatrica

Posts: 33159
*****
 
The most obvious question to ask is did you install the gauges? I seem to remember that this particular aircraft was incorrectly configured with the Gauges folder spelled incorrectly. Look in your FS2002 directory for a duplicate folder named Guages alongside the correct Gauges folder. If it's there transfer all the files inside it to the correct Gauges folder. Do NOT overwrite files/folders if prompted.

This happened a long time ago & I could easily be wrong. Whatever the reason it sounds to me that you didn't install those gauges. These are usually included in a separate folder in the download named Gauges. They should be pasted to the FS2002\Gauges folder as I described above.
 

...

Founder & Sole Member - Grumpy's Over the Hill Club for Veteran Virtual Aviators
Member of the Fox Four Group

Need help? Try Grumpy's Lair

My photo gallery
IP Logged
 
Reply #2 - Dec 13th, 2004 at 6:29am

AlphaBravo   Offline
Colonel
Alpha and Badger ....hehehehe
Reading, Berkshire, UK

Gender: female
Posts: 1050
*****
 
Thanks for the help i will try that

AlphaBravo
 

...
&&
Add me to xfire: alphabravo0sw
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print