Simviation Forum - Cross section...

	Search the archive:

Simviation Main Site | Site Search | Upload Images

Simviation Forum › Design Forums › Aircraft & 3D Design › Cross section...

(Moderators: Mitch., Fly2e, ozzy72, beaky, Clipper, JBaymore, Bob70, BigTruck)

‹ Previous Topic | Next Topic ›

Pages: 1

Cross section... (Read 155 times)

Nov 9^th, 2004 at 3:10pm

skyflirt Offline
Colonel
I love YaBB 1G - SP1!

Posts: 69

Hi !

I'd like to build the fuselage ( and other parts too ) from cross sections,but i didn't find any tutorial about it yet.Could Anybody help for me?

Thanks

IP Logged

Reply #1 - Nov 9^th, 2004 at 3:11pm

skyflirt Offline
Colonel
I love YaBB 1G - SP1!

Posts: 69

Sorry for the duplicated post. Sad

IP Logged

Reply #2 - Nov 9^th, 2004 at 3:30pm

Felix/FFDS Offline
Admin
FINALLY an official Granddad!
Orlando, FL

Gender:
Posts: 1000000627

Are you talking about scale plans cross-sections?

What modelling program are you using?

Felix/FFDS

IP Logged

Reply #3 - Nov 9^th, 2004 at 10:11pm

Lionel_Goh Offline
Colonel
I love YaBB 1G - SP1!

Posts: 67

hello skyflirt,

I'm not sure about FSDS.. but here's what you can do with gmax.

Make a cylinder.. and move the vertices to the cross section you want. Select the front polygon and extrude it.. then mould it into the second cross section..and repeat.

IP Logged

Reply #4 - Nov 10^th, 2004 at 7:22am

Felix/FFDS Offline
Admin
FINALLY an official Granddad!
Orlando, FL

Gender:
Posts: 1000000627

In FSDS .. given a set of cross section backdrops (I usually arrange them in one backdrop image) I'll take a structured tube with as many cross sections as I need, and in cross-section mode, adjust each of the tubes cross-sections. If the next one is similar to the one I just did, I'll copy the current cross section to template, then go to the next one and "conform to template" and adjust from there.

Felix/FFDS

IP Logged

Pages: 1

‹ Previous Topic | Next Topic ›

« Home

‹ Board

Top of this page