Simviation Forum - Installing a working windsock

	Search the archive:

Simviation Main Site | Site Search | Upload Images

Simviation Forum › Design Forums › Scenery & Panel Design › Installing a working windsock

(Moderators: Mitch., Fly2e, ozzy72, beaky, Clipper, JBaymore, Bob70, BigTruck)

‹ Previous Topic | Next Topic ›

Pages: 1

Installing a working windsock (Read 246 times)

Oct 14^th, 2004 at 4:24pm

mauricegambles Offline
Colonel

Posts: 23

Does anyone know how I can install a working windsock in FS2004 using either FSSC or AFCAD ?

IP Logged

Reply #1 - Oct 14^th, 2004 at 6:50pm

racartron Offline
Colonel
So many planes, so little
time
dunwoody, ga

Gender:
Posts: 44

What do ya mean by "workijg?" The default one changes slope and direction based on wind velocity and source -- doesn't it? It does that in FS2002 -- where I fly.

racartron&&------------&&it means something, but I just can't remember what&&

IP Logged

Reply #2 - Oct 15^th, 2004 at 3:01am

Hagar Offline
Colonel
My Spitfire Girl
Costa Geriatrica

Posts: 33159

Quote:

What do ya mean by "workijg?" The default one changes slope and direction based on wind velocity and source -- doesn't it? It does that in FS2002 -- where I fly.

Exactly.

Maurice. I don't know the answer but think it should be possible. I suggest you might do better in the Scenery Design forum.

On your other topic, I successfully removed the default runway on Mull with AFCAD. This leaves a grass strip that doesn't look too bad. I don't know how to change the texture or how it's defined.

Founder & Sole Member - Grumpy's Over the Hill Club for Veteran Virtual Aviators
Member of the Fox Four Group

Need help? Try Grumpy's Lair

My photo gallery

IP Logged

Reply #3 - Oct 15^th, 2004 at 6:01am

mauricegambles Offline
Colonel

Posts: 23

Thanks both for the replies.

Yes the default windsock in FS2004 that appears at some airports does work as described, but how would I use the default windsock as a macro or otherwise add it to a location where it does not exist ?

I too removed the airport at Glenforsa to the correct location using AFCAD, but cannot as you say remove the original ground texture and profile.

I will try the scenery forum as you suggest

IP Logged

Pages: 1

‹ Previous Topic | Next Topic ›

« Home

‹ Board

Top of this page