Search the archive:
 YaBB - Yet another Bulletin Board
 
   
 
  Simviation Forum › Current Flight Simulator Series › Adding Aircraft Traffic (AI) & Gates › AFCAD2 .bgl file problems...
(Moderators: Mitch., Fly2e, ozzy72, beaky, Clipper, JBaymore, Bob70, BigTruck)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1
Send Topic Print
AFCAD2 .bgl file problems... (Read 317 times)
Oct 2nd, 2004 at 8:08pm

PBandJ   Offline
2nd Lieutenant
Keep the rubber side down!
Burbs of Chicago

Gender: male
 Posts: 1
 **
 
Hello all! Newbie to AFCAD2 here. I was running AFCAD2 and made a few changes to an airport I frequent. I returned to AFCAD2 to tweak some more and now the mod file is gone! I looked for another airport that I have an AFCAD2 file for and that is gone too. Only the stock file remains for all my mod files. I removed them from the Addon/scenery files. Rebooted. Reinstalled the files into the Addon/scenery. Launched AFCAD2. Still not there!

So...now I'm at a loss. Any ideas out there pro simr's?

Thanks for your time.
 
Back to top 
IP Logged
 
Reply #1 - Oct 6th, 2004 at 12:18pm

garymbuska   Offline
Colonel
I would rather be flying
Jacksonville, Florida

Gender: male
 Posts: 2850
 *****
 
Check the folder where you have afcad installed at. If you saved them instead of using save as that's where you should find them.
If you use save as you can tell it where to put the file.
if you save it it usually goes in the same folder as AFCAD2 is in. 8)
 
Back to top 
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print
‹ Previous Topic | Next Topic ›
  « Home ‹ Board Top of this page

Simviation Forum » Powered by YaBB 2.5 AE!
YaBB Forum Software © 2000-2010. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge