Search the archive:
YaBB - Yet another Bulletin Board
 
   
 
Page Index Toggle Pages: 1
Send Topic Print
Is it possible to change.... (Read 181 times)
Aug 25th, 2004 at 8:36am

stiz   Offline
Colonel
Yorkshire-England

Gender: male
Posts: 661
*****
 
...the zoom in the 2D cockpit view on the stock aircraft? I just find it really annoying that the views have been zoomed as if you want to go siteseeing you see something good in the panel then switch to side and its not there, then you see it but closer than before.

Also its not like the pilots zoom in when they look behind them is it. Angry

Any help would be appricated.

Stiz
 
IP Logged
 
Reply #1 - Aug 25th, 2004 at 8:47am

Dan   Offline
Colonel
Meet Bogart! Thanks CRAIG!
Carmarthenshire, Wales, Uk!

Gender: male
Posts: 2053
*****
 
I have found this problem but it only happens to eyepoints. Thats if we are talking about the same things! I dont think i've come across this.
Soz Dan
 
IP Logged
 
Reply #2 - Aug 25th, 2004 at 12:40pm

JW49   Offline
Colonel
T6-Texan, Over 40,000
combat missions in Korea

Gender: male
Posts: 348
*****
 
Not sure if this is what you mean,  ???  but you can try it and see.  In settings, controls, assignments check to see if your are set up in "increase selection slightly" and "decrease selection slightly."  If not, I assigned my keyboard up/down arrows to these commands and it holds your cockpit view at the distance you choose or you can zoom in or out at any time, in any view.  Hope this helps.  Smiley
 
IP Logged
 
Reply #3 - Aug 25th, 2004 at 4:14pm

BFMF   Offline
Colonel
Pacific Northwest

Gender: male
Posts: 19820
*****
 
It is possible to change the eyepoint levels, zoom, and directions of each view in your panel.cfg files

By adding 'VIEW_FORWARD_ZOOM=1.00' to your VIEWS section, your zoom will be set to 1
 
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print