The paint textures on the aircraft,  all of them that i flew  where looking sharp and crisp yesterday,  i  flew this morning and now they are blurry.  I checked most all and they are all blurry.
This happens every once in a while,
I have not changed any settings in FS9 or on the ATI 9600 Pro,  They are always the same.
Does anyone know what could be going on here?
Its all the planes,  stock and add ons.
Thanks,  DSH

Hey now,  my boys were up for cat meat at one time.
I saved them So I let em have a little fun here and now.  I hope its no problem with them,  if so well ,  its either North or South.................

Homebuilt,  ASUS P4C 800 Deluxe MB
Overclocked 5%
Intel  Pentium 4  3.0  800  FB
Two Gigs Corsair Twinx Macthed pairs Platinum 3200
ATI Radion 9600 Pro      
ATI 7500 PCI 64mb
Two Monitors
Sony Trinitron Multiscan E540 21"
Dell MM91 17"
Maxtor 120 Gig SATA Hard on
ETC.......

FS9  all sliders to the right except mip at 4
autogen dense
anti alising off,  have full on the card settings       

FPS is running 15 to 25,  sometimes with FL1 Meridian at airports around 8 specialy at MIA,  Have UT running.                  

I doubt i could offer much in the way of good advice to the problem at hand since i dont have that card yet.but if that were my system i would pull that ATI 7500 PCI 64mb out and try to sell it.and up grade in stead of over clocking a system unless you have money to burn on a new motherboard or video card.just my thoughts.but good luck with the problem.

My bad i forgot i read you have 2 monitors.but i just went out and bought the ATI 9600xt video card.and it all looks ok on my system.i dont know how much diffrence there is between the 9600xt and the ATI 9600 Pro you have.but hopefully you will find the problem.