Search the archive:
 YaBB - Yet another Bulletin Board
 
   
 
  Simviation Forum › Design Forums › Aircraft & 3D Design › Exporting problem
(Moderators: Mitch., Fly2e, ozzy72, beaky, Clipper, JBaymore, Bob70, BigTruck)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1
Send Topic Print
Exporting problem (Read 274 times)
May 25th, 2003 at 10:51am

Mustang   Offline
Colonel
F-35 Joint Strike Fighter
Chicago IL

Gender: male
 Posts: 157
 *****
 
when i try exporting a 50000 polygon airplane, once it reaches the point where it compiles, the program crashes and when i look under the error log it says

"error A2071: initializer magnitude too large for specified size"

does anyone know what this means??

any help will be apriciated
 
...
Back to top 
IP Logged
 
Reply #1 - May 26th, 2003 at 1:27am

JohnP   Offline
Colonel
I love YaBB 1G - SP1!

Posts: 182
 *****
 
SmileyWhat program are you using? It sounds like it might be that the polygon count is above the processing limit, therefore the error message.
 
Back to top 
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print
‹ Previous Topic | Next Topic ›
  « Home ‹ Board Top of this page

Simviation Forum » Powered by YaBB 2.5 AE!
YaBB Forum Software © 2000-2010. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge