Search the archive:
 YaBB - Yet another Bulletin Board
 
   
 
  Simviation Forum › Old Flight Simulator Series › FS 2002 › New Beech Baron panel problems
(Moderators: Mitch., Fly2e, ozzy72, beaky, Clipper, JBaymore, Bob70, BigTruck)
‹ Previous Topic | Next Topic ›
Pages: 1 2 
Send Topic Print
New Beech Baron panel problems (Read 1726 times)
Reply #15 - Feb 22nd, 2003 at 12:50am

BFMF   Offline
Colonel
Pacific Northwest

Gender: male
 Posts: 19820
 *****
 
I figured out which gauges were causing the errors to pop up when I turned the radio stack on.

It's the Tempreture and Wind gauges.

I don't understand because all of these are in your baron panel and it works just fine Roll Eyes
 
Back to top 
IP Logged
 
Reply #16 - Feb 22nd, 2003 at 1:03am

FSTipster   Offline
Colonel
There are no stupid questions,
only stupid answers
U.K.

Gender: male
 Posts: 1514
 *****
 
I'd have a play with the order you've got the gauges listed in. Try using the sequence for those three gauges that I used in the Baron panel.cfg.  - not the same gauge numbers, just the order that they appear in.
If that doesn't cure it, the only other alternative is the postioning and size.

Good luck with it.
 
...&&
Click the banner to visit the site
Back to top 
IP Logged
 
Pages: 1 2 
Send Topic Print
‹ Previous Topic | Next Topic ›
  « Home ‹ Board Top of this page

Simviation Forum » Powered by YaBB 2.5 AE!
YaBB Forum Software © 2000-2010. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge