Is there a way to add more waypoints to a flight plan without having to slide the line over another airport?  It's like trying to find a needle in a haystack sometimes.

Mike

I use something like SkyVector to plot out the route; say VOR to VOR and fly over a couple of airports, low and slow.
Then I write down the waypoints on a piece of paper, or I'll have SkyVector up on my laptop (the "electronic kneeboard"). Next, I'll set the 1st waypoint with the GPS, and fly to it. When I'm about 5nm away from the 1st waypoint, I'll refer to my list and plug in the ICAO code for the next waypoint, but I won't hit "enter" on the GPS until I fly over the waypoint.
I'll keep on doing this from point to point until I get to my destination.

SkyVector's Flight Plan feature comes in handy... you can almost use it as a moving map display to track your flight, except your bird isn't shown on the map, of course.

Alan

Mike,

SkyVector is a flight planning website that provides basic flight plan information and superimposes your route on either a Sectional or an IFR Enroute chart, whichever you prefer. When I program the 1st waypoint in the FS 2002 GPS, I use SkyVector as a visual reference to show the route, terrain, etc. it's really easy to use, and very handy. I also have a link to AvnWX, a real time aviation WX site so I can take a look at what the weather's doing.

www.skyvector.com

www.avnwx.com

Alan 

Mike,

Yep. Or else you can program the 1st waypoint using the GPS... whatever works for you the best. I kind of do it as part of my "preflight" checklist. More realism, you know... 

Direct GPS Arrow (till the airport screen shows)
Down Arrow (the ICAO will light up)
Down Arrow (the 1st digit will light up, down arrow to change the digit, right arrow to change to the next one in line until the ICAO code is entered)
ENTER

Good Luck!
Alan