Simviation Forum - Print Page

Simviation Forum
/yabb Design Forums >> Scenery & Panel Design >> Again another very dumb question... /yabb?num=1319466821 Message started by FSX_Dude on Oct 24^th, 2011 at 10:33am

Title: Again another very dumb question...
Post by FSX_Dude on Oct 24^th, 2011 at 10:33am

Ok I downloaded the Airport Design Editor and it supposed to link to FSX (well that is what it says)and it won't link to it and I can't figure out why.I need help soon or my head is ganna explode. >:(

-FSX_Dude

Title: Re: Again another very dumb question...
Post by Fr. Bill on Oct 24^th, 2011 at 1:59pm

Did you read the requirements? ADE requires the freeware version of FSUIPC to be installed.

If you do have FSUIPC installed and still have connection problems, ask Jon for help in the official support forum at FS Developer:

http://www.fsdeveloper.com/forum/forumdisplay.php?f=95

Have you opened and read the extensive manual yet? There are other requirements for ADE to function, including dotNet Framework 3.5...

Title: Re: Again another very dumb question...
Post by FSX_Dude on Oct 24^th, 2011 at 2:35pm

I have all the requirements but still it don't work and I have followed the instructions too. :-[

Title: Re: Again another very dumb question...
Post by FSX_Dude on Oct 24^th, 2011 at 6:18pm

I got it to work. ;DTime to start a making/fixing airports ;D

Title: Re: Again another very dumb question...
Post by Capt.Propwash on Oct 24^th, 2011 at 10:35pm

SO...... what was the problem?

Title: Re: Again another very dumb question...
Post by FSX_Dude on Oct 26^th, 2011 at 8:51pm

I had to start a airport project then it would connect which goes against the manual. :-?

Title: Re: Again another very dumb question...
Post by Scruffyduck on Oct 28^th, 2011 at 5:06am

It doesn't make a lot of sense to connect to FS before a project is loaded which is why you need to start a project and then connect. Why - well perhaps we are wrong but that would just place the ADE display somewhere or the other on the surface of the earth and then the user would need to load whatever was there afterwards.

We need to make the manual clear on that. We are updating it now and I will make sure it is clear on the sequence of events for connecting to the sim.